MacBook Air 13" Mid 2012 AirPort/Bluetooth Card Replacement

1 단계 Lower Case


이 단계에 사용된 도구:
P5 Pentalobe Screwdriver Retina MacBook Pro and Air
$5.99
구매
• Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.
• Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:
• Two 9 mm screws
• Eight 2.6 mm screws
편집
댓글 37개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
2 단계

• Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
• Remove the lower case and set it aside.
편집
댓글 9개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
3 단계 Battery Connector
• As a precaution against accidental discharge or shock, disconnect the battery connector from the logic board.
• Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.
• Be sure to pull the connector horizontally toward the battery, and not straight up from the Air, or you may damage the socket on the logic board.
편집
댓글 3개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
4 단계 AirPort/Bluetooth Card
• Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
5 단계
• Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
6 단계
• Slightly lift the free end of the AirPort/Bluetooth card and pull it out of its socket on the logic board.
• To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.
• Remove the AirPort/Bluetooth card from the Air.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기

작성자

5다른 기여자 명과 함께

Andrew Optimus Goldheart

회원 가입일: 10/17/09

509,435 평판

안내서 407개를 작성함

배지: 44

• 
• 
• 

배지 +41개 더

팀

iFixit iFixit 회원

Staff

120 회원들

안내서 20,078개를 작성함

해당 안내서 넣기

해당 안내서를 사이트/포럼에 작은 위젯으로 포함하려면 크기를 선택하고 아래 코드를 복사하십시오.

미리보기